Low Voltage Temperature Sensors. TMP35/TMP36/TMP37. Rev. E. Information furnished by Analog Devices is believed to be accurate and reliable. However ...The TMP35/TMP36/TMP37 are low voltage, precision centigrade temperature sensors. They provide a voltage output that is linearly proportional to the Celsius (centigrade) temperature. The TMP35/ TMP36/TMP37 do not require any external calibration to provide typical accuracies of ±1°C at +25°C and ±2°C over the −40°C to +125°C temperature range. The low output impedance of the TMP35/TMP36/TMP37 and its linear output and precise calibration simplify interfacing to temperature control circuitry and ADCs. All three devices are intended for single-supply operation from 2.7 V to 5.5 V maximum. The supply current runs well below 50 μA, providing very low self-heating—less than 0.1°C in still air. In addition, a shutdown function is provided to cut the supply current to less than 0.5 μA...

Daylight filter on sensor. Description. The QRD1113/14 reflective sensor consists of an infra- .... This datasheet contains the design specifications for product ...The QRD1113/14 reflective sensor consists of an infrared emitting diode and an NPN silicon phototransistor mounted side by side in a black plastic housing. The onaxis radiation of the emitter and the on-axis response of the detector are both perpendicular to the face of the QRD1113/14. The phototransistor responds to radiation emitted from the diode only when a reflective object or surface is in the field of view of the detector...

"The impedance buffer in the [Basic Flex Sensor Circuit] (above) is a single sided operational amplifier, used with these sensors because the low bias current of the op amp reduces errer due to source impedance of the flex sensor as voltage divider. Suggested op amps are the LM358 or LM324." "You can also test your flex sensor using the simplest circut, and skip the op amp." "Adjustable Buffer - a potentiometer can be added to the circuit to adjust the sensitivity range."...Features. - Angle Displacement Measurement. - Bends and Flexes physically with motion device. - Possible Uses. - Robotics. - Gaming (Virtual Motion) ...

Structure and configuration of MQ-2 gas sensor is shown as Fig. 1 (Configuration A or B), sensor composed by micro AL2O3 ceramic tube, Tin Dioxide (SnO2) ...Resistance value of MQ-2 is difference to various kinds and various concentration gases. So,When using this components, sensitivity adjustment is very necessary. we recommend that you calibrate the detector for 1000ppm liquified petroleum gas,or 1000ppm iso-butaneconcentration in air and use value of Load resistance that( RL) about 20 KΩ(5KΩ to 47 KΩ). When accurately measuring, the proper alarm point for the gas detector should be determined after considering the temperature and humidity influence.

Sensors. Data Sheet. V 0.9, 2011-06. Preliminary. TLE5012B. Angle Sensor. GMR-Based Angular Sensor. Page 2. Edition 2011-06. Published by. Infineon ...